ELMER FUDD PICTURE FULL

This will allow you to adjust it later to ensure it fits perfectly with the Bugs model.ĥ - Be sure to insert the eye_blacks in correctly (left/right are different) and not upside down. You can glue this in, or add a bit of double sided tape to the left scythe_handle where it goes into the left hand. This will also ensure that the gun is positioned correctly when placed against the Bugs model.Ĥ - The optional scythe snaps into the right hand but is not snug enough into the left hand to hold it into position. It should fit in position with just a slight snap. Just remember to leave enough time for the glue to set before combining too many parts.ģ - I glued the gun together but did not glue it to the hands. I have 'fat fingers' and a shaky hand, so the sticky glue works out best for me, especially with small pieces. The sticky glue allows more time to position the parts than a fast drying superglue. I ordered some more filament and the color was identical, as though it came off the same run.ġ - Take your time gluing the model together and enjoy the process.Ģ - I used E6000 sticky craft glue to put this model together. I had some Paramount3D PLA Military Brown from five years ago and ran out while printing this model. So, choose your colors as you see fit.Ĥ - Fun fact. For the smaller parts, a good first layer is helpful.ģ - Looking at Elmer Fudd pictures I found that his colors varied somewhat, especially his gun. When setting up my prints I prefer to be conservative, especially since the base of many parts are hidden when inserted into another part. Only the tips of the ears would need supports.Ģ - There are some pieces that may need brims or rafts, use your discretion.

The head is presented with built-in supports as well as an optional piece if you want to use your slicer supports. Green: (Paramount3D PLA - St Andrews Green)ġ - No supports are required. Head_without_supports (optional piece if you use your slicer supports) Skin: (Paramount3D PLA - Universal Beige)

(note: this red is not as bright as other red filament)īrown: (Paramount3D PLA - Military Brown) Refer to the notes below for a few helpful printing and assembly instructions. If you have the proper filament colors, no painting is needed. One piece contains built-in supports, an optional part without the built-in supports is also supplied if you want to use your slicer supports.

ELMER FUDD PICTURE FULL

The following is a placeholder for the Buggs model that will be paired with Elmer to complete the full iconic scene with Bugs' finger in Elmers gun (or scythe if you prefer): To honor this change, this model contains an optional scythe that you can use interchangaebly with the gun. In a new short titled 'Dynamite Dance,' Fudd uses a scythe as he chases his nemesis Bugs Bunny. announced that Elmer will no longer have a gun. He speaks in an unusual way, replacing his Rs and Ls with Ws, so he often refers to Bugs Bunny as a 'scwewy' or 'wascawwy (rascally) wabbit'.Įlmer's trademark phrase is 'Shhh. His aim is to hunt Bugs, but he usually ends up seriously injuring himself and other antagonizing characters.

Looney Tunes/Merrie Melodies series, and an adversary of Bugs Bunny. Fudd, a fictional cartoon character in the Warner Bros.

Elmer fudd picture